Yang Sun App Studio
Back to Blog
2026-11-175 minUtility

Do tank heads add volume?

Do tank heads add volume?

Author: SunClaw Team · Updated: 2026-11-17

The short answer

Yes, unless the head is flat.

In Tank Volume Calc Pro, the length of a horizontal cylinder is the straight shell, not the outside length including the heads. Total volume = shell volume + both heads. A flat head adds 0. Elliptical, hemispherical, and dished heads add both ends.

Take a tank with inside diameter 2 meters (radius 1 meter) and a straight shell 4 meters long. The shell alone is 12.57 cubic meters. The figures are the app's 400-step integral, rounded to two decimals.

HeadStick-out, one endBoth headsTotal
Flat0012.57 m³
Elliptical0.50 m2.09 m³14.66 m³
Dishedabout 0.39 m1.58 m³14.15 m³
Hemispherical1.00 m4.19 m³16.76 m³

On this shell, hemispherical heads add about 4.19 cubic meters over a flat head. The outside length changes too: flat stays 4 meters, elliptical is 5 meters, dished is about 4.78 meters, hemispherical is 6 meters. If you type the outside length into Length, the shell is too long and the volume comes out high.

What the four heads are

An elliptical head is half a radius deep. At a radius of 1 meter, one end sticks out 0.50 meters.

A hemispherical head is one radius deep. One end sticks out 1 meter. The two ends are half a sphere each.

The dished head is a torispherical shape: crown radius equals the tank diameter, and the knuckle radius is 10% of the diameter. At a radius of 1 meter the crown radius is 2 meters, the knuckle is 0.20 meters, and one end is about 0.39 meters deep.

A flat head is not run through that integral. Both ends stay at 0.

A vertical tank is a different shape. Its bottom is flat or conical. It does not use these four horizontal heads. Do not put a vertical tank through the table above.

Level is not a constant times depth

The head changes the shape, so the volume per centimeter of level is not a constant, especially on a horizontal tank. How a partial fill becomes a volume is in horizontal tank level. Liters, gallons, and oil barrels are in how many gallons in a barrel. Pick the head first, then switch the display unit. Do not multiply a horizontal level by one gallons-per-centimeter number.

A dip chart can step by 1/4 inch, 1/2 inch, 1 inch, 1 centimeter, 5 centimeters, or 10 centimeters. The step only sets how dense the chart is. It does not change the head.

FAQ

Q: Do I type the outside length? A: No. Length here is the straight shell. The head's stick-out is computed from the head type and added into the total.

Q: Why does a flat head leave the volume unchanged? A: Its depth is 0, so both ends add 0. The total is the shell alone.

Q: Which is larger, elliptical or hemispherical? A: At the same radius, one hemispherical end is twice as deep as one elliptical end, and the two ends add more volume. In the table the hemispherical total is 16.76 cubic meters and the elliptical total is 14.66.

Q: Can I use this table for a vertical cone bottom? A: No. A vertical tank has a flat or conical bottom, not these four horizontal heads.

Pick the head before you read the volume

If the drawing shows a hemisphere and the app is still on the default flat head, this 2 meter by 4 meter shell is short by about 4.19 cubic meters. Change the head to the one on the drawing first.

Tank Volume Calc Pro

#tank head#tank volume#elliptical head